sporties

petrol, oil and plug leads

thats all it'd need to run, though there is still a way to go, but i am very happy with the way it looks.

a few more bits to do like convert the headlight to dual filament, change the rear light and do exhaust mounts, then strip and get the frame blasted and welded.

So close yet so far.

shifting

number plate mount from ebay

a lot of trimming and a few holes later and i am happy with its place though i might see if i can get it the other side of the bearing support where its spaced out for the super nut, but this will mean removing a lot of material from the support.

new- old risers

mmmm....

steam roller

pans

everyday i'm shovelin..

flatties....

saw this and thought you might like

project update- rigid seat mounts

just what i was after, the seat sits on the posts and is located by the slotted bar to stop side movement, but can be removed and springs fitted if i want.